[. . . ] Programming the Polaroid Universal Remote Control Following are two sets of instructions for programming your Polaroid Universal Remote Control to work with other devices in addition to your Polaroid TV. [. . . ] After you enter the last digit: a) If the code you entered is the correct code for your device, you will see the LED blink twice. b) If the code you entered is not the correct code for your device, you will see the LED blink once. 5 Press the Power button (top right-side button) on the remote and your device power should turn on. If the power does not turn on, repeat the entire procedure beginning with step 1. If you are unable to program the remote properly after two or more attempts using the Direct Programming Setup, go on to the Auto Code Search Setup. 39 Auto Code Search Setup This method does not require use of the Device Code Table. 1 Turn the device power off and point the Polaroid Universal Remote Control at the device you wish to control. 2 Momentarily press a device button on the Polaroid Remote Control (TV, DVD, CBL, or AUX). When you release the device button the red LED at the top of the remote will blink once. [. . . ] 8 When the device turns on, press and hold the SET button until you see the LED blink twice. [. . . ]